D-Link Forums
The Graveyard - Products No Longer Supported => Access Points / Extenders => DAP-1522 => Topic started by: selvag on February 16, 2010, 11:01:20 AM
-
I have a bit of a strange problem and was wondering if anyone can give any insight into this because I'm at a loss. I have my 1522 in my living room connected to my PS3 and XBox 360. I am using bridge mode to connect to my N network streaming from my Netgear WNDR3700. The connection is fantastic, I can stream 1080P content via XBox live with no issues. The problem comes when I try to use Media Center on my Windows 7 PC through my XBox.
When I first setup this network, I had no issues with Media Center...everything worked fine, but now, every time I try to watch any recorded SD content off of my Media Center, I'll get about 2 minutes in and it freezes and loses connection to the PC. I noticed that on the Bridge the normal operating mode is the Orange bridge light flashing slowly. When I lose this connection, the bridge light is off for about 5 seconds right before both the bridge light and the AP light flash then it returns to normal operation. I'm assuming this is a reboot. All settings are maintained and it connects back to the network automatically.
Can anyone shed any light on this? Like I said, everything works beautifully except for media center. I'm using the 1.21 firmware. Thanks in advance.
-
Just to add...some things I've already tried:
-Changing N Channel
-Resetting Bridge to factory defaults and reconfiguring
-QOS on/off
-Different cables
-Network connection check (Signal is amazing. Even the media center Network Tuner lists the connection at full green bars saying I can stream HD content)
-Disabled WPS
-
It's been a while since I originally posted this. Bumping to see if anyone knew to the forums can help out.
-
try setting wireless signal stregnth to 75% , maybe a powersupply problem ? Try a different power plug ?
-
I have a very similar setup and the same scenario was happening too. In my situation when I am streaming HD then the DAP is rebooting. This is consistent with firmware 1.21, 1.20 and 1.10 also. Finally, I brought a netgear powerline XAVB101. I am using DAP for some other purpose.
Thanks