D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DGL-4500 => Topic started by: Maverick494 on March 02, 2010, 07:54:48 PM
-
So here is the situation: I was uploading the new firmware to the router and poof power went out at my house for about an hour. Now all I get when I go to 192.168.0.1 is this screen that says IIS7 Welcome. Now on the digital display screen it says the firmware update took and it shows a connected internet, but when I connect a computer it says no internet access. It is also showing that it is blocking packets like it is a Land Attack.
I am open to ideas here.
-
ok, update. I have internet on the PC again, but I still get the wierd IIS7 screen when I go to 192.168.0.1
-
Update 3:
It must be a computer issue that is blocking the 192.168.0.1 IP, because using the http://dlinkrouter works and I was able to get it all reset and good to go.
-
Glad you were able to find the resolution for your issue. If anything, always do a Factory Reset should something get horked like that. Usually the factory reset will set it back to defaults. We even try to include this procedure even after a FW update. Update then factory re-set then you should be good after that. Hope it works well for you.
-
The hard reset covers a multitude of problems. I've had to use it a couple of times myself.