D-Link Forums

The Graveyard - Products No Longer Supported => Access Points / Extenders => DAP-1522 => Topic started by: eddysback on March 20, 2010, 07:34:46 PM

Title: Visibility remains greyed out
Post by: eddysback on March 20, 2010, 07:34:46 PM

The dap-1522 is a good piece of hardware. I use it in AP Mode and everything works fine. My only headache is that I cannot select invisible in the visibility status in the wireless network settings. I'm using 5mhz band with WPA2 enabled. As said everything else works flawlessly but this  >:( visibility mode is selected "visible" and the invisible button remains greyed out.
Any help would be appreciated

Title: Re: Visibility remains greyed out
Post by: Inha on September 24, 2010, 05:42:57 AM

Same here! Any Ideas?

Hardware version A2, firmware V1.21

Title: Re: Visibility remains greyed out
Post by: RichH25 on October 05, 2010, 06:30:16 PM

In the Manual Wireless Network Setup, go to the Wi-fi Protected Set-up section and uncheck "enable".  This should make the Visibility selection box active.  This worked for me.