D-Link Forums

The Graveyard - Products No Longer Supported => D-Link NetDefend Firewalls => Topic started by: sdanga on May 02, 2010, 11:52:28 PM

Title: Configuring DFL-210
Post by: sdanga on May 02, 2010, 11:52:28 PM

Good morning to all,
I have a question about the configuration of DFL-210. Is it possibile to configure it filtering internet access for each IP address of my network? And if it's possible, how can I do it? Thanks for your help.

Title: Re: Configuring DFL-210
Post by: Fatman on May 03, 2010, 08:24:00 AM

IP Rules will be key, if you write exceptions from the default allow above it that drop or deny the IPs you are worried about that will be effective.  As would removing the default allow(s) and adding rules NAT'ing the traffic you specifically want to permit.

Title: Re: Configuring DFL-210
Post by: scrubsguy on July 27, 2011, 02:36:42 AM

is possible... ive done it, but is this for a office or home enviroment?