D-Link Forums
The Graveyard - Products No Longer Supported => D-Link Storage => DNS-343 => Topic started by: Melnok on May 15, 2010, 08:30:14 PM
-
Hello. I purchased the DNS-343 today and installed 4 x 2TB drives. Initial boot up was successful, but I encountered the 94% formatting issue. I proceeded to update the firmware (1.02 was installed) to 1.03, but the progress bar for installing the firmware appeared to hang about one-third of the way in. After about half an hour of waiting I tried powering down but the system was unresponsive so I pulled the plug. Now when I try booting up the device is stuck at the "System is booting..." message with the fans going. With or without drives installed I can't appear to get past this screen.
While I fear the failed firmware upgrade is causing this, I was hoping someone might know if I would be seeing a different message or behavior if there was indeed a botched firmware and that this eternal boot issue is perhaps unrelated. An even greater hope of mine is that there's some way to fix this thing :) Thanks!