D-Link Forums

The Graveyard - Products No Longer Supported => D-Link NetDefend Firewalls => Topic started by: ilGrifo on June 09, 2010, 02:57:20 AM

Title: split outgoing traffic on wan1 and wan2 with dfl-800
Post by: ilGrifo on June 09, 2010, 02:57:20 AM

Hi NG,

in my scenario there are 2 adsl line, one very fast and one slow

how to configure my DFL-800 to use pool of IP's on wan 1 and other on wan 2 ?

I don't need a fail over or load balance, a simple configuration to divide the outgoing traffic.

thanks, regards
Andrea F.

Title: Re: split outgoing traffic on wan1 and wan2 with dfl-800
Post by: danilovav on June 09, 2010, 04:12:57 AM

Don't understand what you want. How to divide? Statically divide clients - some thru wan1, some thru wan2? Or what?

Title: Re: split outgoing traffic on wan1 and wan2 with dfl-800
Post by: Fatman on June 09, 2010, 08:36:07 AM

A routing rule with 2 routing tables, the source network of the routing rule will determine the divide.

Title: Re: split outgoing traffic on wan1 and wan2 with dfl-800
Post by: silver_surfer30 on June 09, 2010, 12:42:44 PM

why not using outgoing routing load balance feature ?

Title: Re: split outgoing traffic on wan1 and wan2 with dfl-800
Post by: ilGrifo on June 10, 2010, 05:30:21 AM

Quote from: silver_surfer30 on June 09, 2010, 12:42:44 PM

why not using outgoing routing load balance feature ?

too complex for me now!

step by step I learn about firewall.

in this moment I want to test a configuration with a pool of IP's on wan1 ( all services ) and another pool on wan2 ( all service )

in the next I ' ll configure a load balance . . .

bye.
A.F.

Title: Re: split outgoing traffic on wan1 and wan2 with dfl-800
Post by: Fatman on June 10, 2010, 08:24:18 AM

A proper load balance is easier nowadays.  No second routing table or routing rules, just a route load balancing instance.

Title: Re: split outgoing traffic on wan1 and wan2 with dfl-800
Post by: ilGrifo on June 14, 2010, 03:07:17 AM

Quote from: Fatman on June 10, 2010, 08:24:18 AM

A proper load balance is easier nowadays.  No second routing table or routing rules, just a route load balancing instance.

Is there an "how to " about the feature ?
the documentation is for the old firmware.

Title: Re: split outgoing traffic on wan1 and wan2 with dfl-800
Post by: danilovav on June 14, 2010, 04:32:04 AM

Refer manual 2.25 - http://ftp.dlink.ru/pub/FireWall/DFL-800/Description/manual_2_25_01/NetDefendOS_2.25.01_Firewall_UserManual_V1.08.pdf

Title: Re: split outgoing traffic on wan1 and wan2 with dfl-800
Post by: ilGrifo on June 14, 2010, 05:45:17 AM

thanks,
I'll RTFM

Andrea F.