D-Link Forums

The Graveyard - Products No Longer Supported => Access Points / Extenders => DAP-1360 => Topic started by: zdhr on June 27, 2010, 10:52:21 PM

Title: How to set WAN IP
Post by: zdhr on June 27, 2010, 10:52:21 PM

Hello,

I cannot find WAN settings to set static IP obtained from my ISP. Is this possible?

(as an access point mode connected to internet using ethernet cable to cable modem)

Title: Re: How to set WAN IP
Post by: Guyon on April 24, 2011, 10:13:51 AM

IF you have you DAP-1360 set as Access Point then:

1) If your ISP supplies an IP via DHCP  (Most likely)
Go into LAN settings and set it to Dynamic IP

2) If you have a static IP address from you ISP then
Go into LAN settings and set it to Static IP and add the address

IP Address :    
Subnet Mask :    
Gateway Address :    

3) You probably also need to enable DHCP Server addresses (same setup page) for internal IP addresses for multiple devices attaching to the DAP-1360.