D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-655 => Topic started by: Trebor343 on March 05, 2008, 08:18:47 PM

Title: Can I go back to 1.10 from 1.11 ?
Post by: Trebor343 on March 05, 2008, 08:18:47 PM

1.11 has practically destroyed my router.

wireless issues, router not getting an IP from my cable modem unless I hard reset the modem, my vonage now even more so useless than it was under 1.10...

is it possible to go back to 1.10 ?

Title: Re: Can I go back to 1.10 from 1.11 ?
Post by: davevt31 on March 05, 2008, 08:47:29 PM

Yes just flash it with the 1.10 binary.

When you went to 1.11 did you reload an old configuration file or put back settings manually.  There has been a few posts saying they had issues using older config files and they were fixed by doing the router settings from scratch.

Title: Re: Can I go back to 1.10 from 1.11 ?
Post by: kevinla on March 07, 2008, 09:36:05 AM

Quote from: Trebor343 on March 05, 2008, 08:18:47 PM

1.11 has practically destroyed my router.

wireless issues, router not getting an IP from my cable modem unless I hard reset the modem, my vonage now even more so useless than it was under 1.10...

is it possible to go back to 1.10 ?

I had the same problem.  I was running smooth on 1.10 and 1.11 ruined my connecton.

Title: Re: Can I go back to 1.10 from 1.11 ?
Post by: Lycan on March 07, 2008, 02:31:53 PM

Yes you can roll the firmware back.
How did 1.11 ruin your connection?