D-Link Forums

The Graveyard - Products No Longer Supported => D-Link NetDefend Firewalls => Topic started by: addicted on July 06, 2010, 01:21:56 PM

Title: DFL-800 SIP Register
Post by: addicted on July 06, 2010, 01:21:56 PM

Dear All

I am using DFL-800 with Dual Wan, load balancing with bandwith shaping through pipes

I am trying to figure out following scenario

Routing Rules:
#  Name  Source interface  Source network  Destination interface  Destination network  Service  Comments 
1  https  lan  all-nets  wan1  all-nets  https   
2  standard  lan  all-nets  WAN  all-nets  http-outbound   
3  Yahoo  lan  lannet  WAN  all-nets  Yahoo   
4  Custom  lan  all-nets  WAN  all-nets  Custom-Ports   

I want all of my SIP register to go through Dmz. Is there any way I can route all SIP traffic coming from LAN to any Specific Network WAN



Thanks

Title: Re: DFL-800 SIP Register
Post by: Fatman on July 06, 2010, 01:44:08 PM

If you have a routing table describe how you want traffic to be routed, then simply create a routing rule that applies to that traffic before any other rule would.  If you already have the level of config seen above then I don't see how this is a "new" scenario.