D-Link Forums
The Graveyard - Products No Longer Supported => Other D-Link Products => Topic started by: kmtenor on July 07, 2010, 02:30:39 PM
-
Is it possible to use the DWL-3200AP (not Rev B, Firmware 2.2) as a bridge between a non-DLink wireless network (it is a Trapeze) and a wired network using WDS mode? I have tried all afternoon, and have had no luck.
The strangest part is that, the first time I tried setting it up, the "Scan" button on the WDS config page actually did show all of the networks that were available - but there were no radio buttons with which to select them. I have put the appropriate MAC address and ssid in to the confi manually, with no results.
Since that initial success with the "Scan" button, I have had no further luck getting a scan to produce any results. Yes, there is signal present - I am using a laptop that is accessing the wireless network I wish to bridge without any issues.
I have tried all three browsers.
I need a new bridge because the Linksys WET54G we were using as a bridge has died. I have the DWL-3200 in stock, and was hoping I could just use that rather than tracking down a replacement for the Linksys (which is also looking quite doubtful, as I need an external antenna mount, and nothing on the market today offers one)
Thanks in advance.
-Kevin