D-Link Forums

The Graveyard - Products No Longer Supported => Hubs and Switches => DGS-1224T => Topic started by: dangill14 on July 14, 2010, 12:16:12 AM

Title: DGS-1224T Trunking Issues?
Post by: dangill14 on July 14, 2010, 12:16:12 AM

Hello All,

   We have purchased a D-Link 1224T (Rev D2) running firmware 4.21.01, and have noticed an interesting issue when trunking ports.

   When we trunk 2 GE ports together, the trunking appears to work fine, and we can ping through / pass traffic; however when we increase to 4 GE ports, we can not ping through / pass traffic.

   Any thoughts?

Thanks,

Dan.

Title: Re: DGS-1224T Trunking Issues?
Post by: Fatman on July 14, 2010, 08:38:58 AM

Which 4 ports on each switch?

Title: Re: DGS-1224T Trunking Issues?
Post by: dangill14 on July 14, 2010, 08:08:53 PM

Quote from: Fatman on July 14, 2010, 08:38:58 AM

Which 4 ports on each switch?

We have tried with 17, 18, 19, 20; and 9, 10 , 11, 12.

Dan.

Title: Re: DGS-1224T Trunking Issues?
Post by: Fatman on July 15, 2010, 03:43:04 PM

Have TS take a look at this, I think we are going to need a little bit finer grain than is available via a forum.