D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DIR-655 => Topic started by: pabrams on August 14, 2010, 10:23:22 AM
-
I have a 655, A4, 1.34NA code. I have a tunnel configured and working from Hurricane Elec to the outside. A sniffer trace on the outside of the 655 shows v6 ping replies coming back. However, I cannot get the 655 to forward protocol 41 to my PC. Inside traces show nothing being forwarded. I have configured Protocol as "Other" and entered 41 in the box below protocol. Is this correct? I tried configuring DMZ under Firewall as well and that did not work.....anyone got this working?
Thanks
Pat
-
The 655 does not need forwarding the IPv6 tunnel protocol, since the W7 & Vista setup require the client's local IPv6 address. If more clients run a tunnel to an external endpoint, the first one to create the tunnel will receive the respons, the 655 passes through all data.
-
Is there any way to see if the 655 thinks there is another client? I have been using a Win7 machine and a vista machine, trying both out...disabling v6 stack when switching around. Did several reboots in between, so I would think any state table was cleared. I will go back and boot the 655 and make sure v6 is disabled on PCs, then crank up one client.
I do know that that whatever the issue is, the echo reply from HE is returning to the outside interface of the 655....just not making it back inside.
-
OK, I got it resolved...had to go back and clear off my ipv6 interface and reapply HE commands. The error I made was using the outside address when adding the tunnel, when I should have been using the 192.168 address. There is a note on the HE page about this, guess I glazed over it the first time.
Thanks for your asssitance!