D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-615 => Topic started by: alejandro.anv on October 06, 2010, 12:59:25 AM

Title: Dir 6-15 Rev D3 firmware
Post by: alejandro.anv on October 06, 2010, 12:59:25 AM

Where can I download the firmware for dir-615 rev D3?

I installed dd-wrt and had some problems, then I want to try with the original firmware to see if there is the same problem.

I bought the router in Spain, but dlink.es has no info about dir-615. USA site has formware for dir-615 C and E, but noto for D. UK site has firmware for D1 but not for D3.

Is D1 firmware good for D3? Where can I find firmware for D3?

Title: Re: Dir 6-15 Rev D3 firmware
Post by: carbonic on October 06, 2010, 10:04:10 AM

According to the danish site D1 and D3 uses the same firmware.

Title: Re: Dir 6-15 Rev D3 firmware
Post by: Skello on October 07, 2010, 10:26:49 PM

ftp://ftp.dlink.biz/dir/dir-615/driver_software/DIR-615_fw_revd_411DEb15_ALL_de_20100303.zip should work.

You only need the DIR-615D_FW411EUB15.bin file inside (it's in English).

Title: Re: Dir 6-15 Rev D3 firmware
Post by: alejandro.anv on October 08, 2010, 02:40:42 AM

Quote from: Skello on October 07, 2010, 10:26:49 PM

ftp://ftp.dlink.biz/dir/dir-615/driver_software/DIR-615_fw_revd_411DEb15_ALL_de_20100303.zip should work.

You only need the DIR-615D_FW411EUB15.bin file inside (it's in English).

Thank you very much

I've tried the recovery procedure, by holding down the reset button and powering up the router. The power led flashes but it does not anwers pings to 192.168.0.1 nor 192.168.0.254.

Title: Re: Dir 6-15 Rev D3 firmware
Post by: JavaLawyer on October 08, 2010, 04:55:04 AM

You may want to try this alternative factory default recovery procedure:
http://forums.dlink.com/index.php?topic=11596.msg69028#msg69028

Title: Re: Dir 6-15 Rev D3 firmware
Post by: Skello on October 08, 2010, 11:30:43 AM

To access the Emergency Room Web interface follow these steps:

• Unplug the router's power cord and wait 20 seconds.
• Get a pin, push the RESET button and KEEP IT PRESSED.
• Connect the power cord back (while still keeping the reset button pressed)
• Keep the reset button pressed for an additional 5 seconds after connecting power cord and then release. At this point you should see the power button blinking orange.
• Connect over a WIRED connection to the router and set your network adapter IP MANUALLY to 192.168.0.2
• Open http://192.168.0.1 in a browser. You should see a white page with a Browse and Upload button.

The "set your IP manually" part is very important.

Title: Re: Dir 6-15 Rev D3 firmware
Post by: alejandro.anv on October 10, 2010, 10:46:02 AM

Thank you everyone for the help.

I can add something to the instructions. Don't test pinging the router. I was confused by this because I pinged the router in order to check if the ip is correct and emergency boot does not answer the pings.