D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DGL-4500 => Topic started by: Puffnstuff on November 11, 2008, 11:53:14 AM
-
I flashed to the new fw this am and everything seems to be working so far. I did notice that I had to reset it and then manually reenter all of my info instead of loading a saved config file. Port forwarding with games is working now.
-
I flashed to the new fw this am and everything seems to be working so far. I did notice that I had to reset it and then manually reenter all of my info instead of loading a saved config file. Port forwarding with games is working now.
Good to hear! any further comments/concerns are appreciated!
-
1.15 did not fix the PS3 Remote Start Issue I have been posting about that is so very easy to test. Thread explaining the issue is below.
http://forums.dlink.com/index.php?topic=2403.0 (http://forums.dlink.com/index.php?topic=2403.0)
-
Wow this seems to work for about ten minutes and then stops responding to any kind of setting I try to put on it, Should have stayed with 1.02 ???
-
Wow this seems to work for about ten minutes and then stops responding to any kind of setting I try to put on it, Should have stayed with 1.02 ???
I agree, after changeing some settings and rebooted, I wanted to add a gamefuel fuel rule and clicked save, it would just freeze and reboot without the rule that i just put in. =/
-
Upgraded properly for me; and I was able to restore the configuration from the file as well. All I had to do was reset the admin password. Security, MAC assignments, etc. were all put back in place.
-
Upgraded properly for me; and I was able to restore the configuration from the file as well. All I had to do was reset the admin password. Security, MAC assignments, etc. were all put back in place.
I to had no problems with the upgrade.
-
I still have the same issue as before with 1.12/1.13, unlike I did with 1.02. All I notice is that it does not block the game when I open the ports. But from what I see it has fixed the issues for some, so thats a start.
-
About to try it.. hopefully it all turns out good.
-
I agree, after changeing some settings and rebooted, I wanted to add a gamefuel fuel rule and clicked save, it would just freeze and reboot without the rule that i just put in. =/
Same exact thing is happening to me, this is pissing me off big time since I cannot configure my router. I cannot turn off wifi, it will freeze up and reboot, i cant password protect it, anything I do it freezes and reboots. So now my network is totally opened and unsecure. I have tried resetting to default and reflashing, same problem.
-
When you upgraded the firmware, did you disconnnect everything from the router first before flashing it or did you leave everything connected?
The only network cable that should be connected to the router is the one that is connected to the system you are using to upgrade the router. Even the WAN port should be disconnected.
This is to prevent any possible Unwanted network traffic which might cause the firmware upgrade to become corrupt or possibly to fail. Also make sure you disable any AntiVirus software before starting the upgrade.
Read this thread and try to re-flash the router once again (http://forums.dlink.com/index.php?topic=2914.0) to see if you can get it to take.
-
Well it decided to stop accepting changes so I had to roll back to 1.12. Please let us go back to 1.02 and be done with it.
-
After I first flashed mine to 1.15 (straight from 1.02) it also did the thing where the settings wouldn't take. I used the reset on the back (held it for a minute) and then all was well. I suggest trying that before giving up on it.
Also, I ended up reflashing mine again to fix a problem with streaming quality being poor and now I am super happy, everything works perfectly.