D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-655 => Topic started by: supercoqui on August 07, 2007, 07:19:07 PM

Title: Firmware 1.04 Hardware A2 virtual servers problems
Post by: supercoqui on August 07, 2007, 07:19:07 PM
After much testing I discovered what was causing my constant disconnects. Virtual servers for software that uses too much bandwidth.
I setup Net2go from network magic and it worked ok. I setup virtual servers with utorrent and downlaoding a lot of torrent data and I started to experience problems every minute on the minute. The connections would get dropped and alot of other problems.

It is good to notice that I had the same ports forwarded in the prot forward list to the same IP. Also I am running firmware version 1.04 hardware version A2. Didnt see information about this posted so I decided to go ahead and add it.
Title: Re: Firmware 1.04 Hardware A2 virtual servers problems
Post by: Lycan on August 15, 2007, 10:11:10 AM
have you configured the QoS for the router?
Title: Re: Firmware 1.04 Hardware A2 virtual servers problems
Post by: on August 15, 2007, 10:48:16 AM
After much testing I discovered what was causing my constant disconnects. Virtual servers for software that uses too much bandwidth.
I setup Net2go from network magic and it worked ok. I setup virtual servers with utorrent and downlaoding a lot of torrent data and I started to experience problems every minute on the minute. The connections would get dropped and alot of other problems.

It is good to notice that I had the same ports forwarded in the prot forward list to the same IP. Also I am running firmware version 1.04 hardware version A2. Didnt see information about this posted so I decided to go ahead and add it.

Use 1.02 or 1.05