D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DIR-655 => Topic started by: wheelblur on February 16, 2011, 11:11:20 AM
-
I am having an issue opening a port (4040) on the 655 for my Fedora-based subsonic server. Inside the LAN, I can see the device from other peer machines, so I am confident the port is open and listening. However, I can't seem to get to the machine-port from outside/internet.
I have tried Virtual Server and Port Forwarding with single port. The server has a stactic IP which I've included in the DHCP range and outside the range. I have a DSL connection (AT&T), modem only. I have updated firmware. I have exhausted the Subsonic community's knowledge, everything points to the router, but all the settings seem correct. What am I missing? Is if possible there is a defect in the router? (don't laugh). Is there a way to trace a request to that port to see where it is hanging?
(yes, I've STFA, but don't know what else to do).
thx,
'blur
-
I'm using OpenDNS for my dynamic IP address, port 80 on my local reserved IP address (192.168.0.100) and using the virtual servers list (subsonic, 80, TCP, Always, 192.168.0.100, 80, 6, Allow All).
After telling Norton about the allowing access to the program and windows service it worked fine. Things did not work fine when using the subsonic hosted dynamic dns address. I had troubles accessing direct from the local network, always worked from the external dynamic ip address. Using Windows 7 64 bit through a DIR-655 A3 V1.11 (old firmware), iphone 4 client. Detailed help for subsonic is hard to find.
-
I am having an issue opening a port (4040) on the 655 for my Fedora-based subsonic server. Inside the LAN, I can see the device from other peer machines, so I am confident the port is open and listening. However, I can't seem to get to the machine-port from outside/internet.
I have tried Virtual Server and Port Forwarding with single port. The server has a stactic IP which I've included in the DHCP range and outside the range. I have a DSL connection (AT&T), modem only. I have updated firmware. I have exhausted the Subsonic community's knowledge, everything points to the router, but all the settings seem correct. What am I missing? Is if possible there is a defect in the router? (don't laugh). Is there a way to trace a request to that port to see where it is hanging?
(yes, I've STFA, but don't know what else to do).
thx,
'blur
The router doesn't support loopback though port forwards. So you cant reach inside your LAN.
Test from "real" outside.