D-Link Forums
The Graveyard - Products No Longer Supported => D-Link Storage => DNS-323 => Topic started by: lookingforinfo on February 17, 2011, 07:47:45 PM
-
For a number of reasons I just purchased a second DNS-323 on E-Bay. It was listed as "New" but it had been previously run through the Easy Setup Utility. I used the hardware reset button to reset values, but I was not given the option to reformat the disks. The disks are currently configured as RAID-1 and I would like to change that to Standard. Is this possible?
The current Firmware is 1.07.
I ended up restarting the system with only Drive 1 installed. I was then able to reformat the drive. When Drive 2 was inserted and the system restarted, Drive 2 automatically appeared as a Standard disk. I had hoped for a easier process, but this way there will be no accidental reformatting of the drives.