D-Link Forums

D-Link IP Cameras for Home => DCS series Network Cameras => Topic started by: jkreijger on March 26, 2011, 10:23:50 AM

Title: Problem with DCS-2121 after using Reset button
Post by: jkreijger on March 26, 2011, 10:23:50 AM

Hi,
I connected my camera to my router with a network cable. It is a DCS-2121, H/W Ver A2, with firmware 1.04_FR.
It received an IP address and I could access it fine with a web browser.
Then I configured it to work wirelessly.
I disconnected the cable but the camera wasn't accessible.
Since I couldn't find it I re-attached it with a network cable, but this didn't work.
So I pressed the Reset button to start over again.
However, now I cannot get it to work anymore.
When I plug in the camera and have it connected with a network cable to the router the status light remains RED.
When I plug it in without a network cable the status led remains RED.
When I connect it with a network cable to a computer directly, the status led remains RED.
I've tried changing the network settings of my router to use 192.168.0.x as range, but it makes no difference. In all cases the status indicator remains RED.
Any suggestion of what else I can try?
Thanks,
Jeroen.

Title: Re: Problem with DCS-2121 after using Reset button
Post by: i8u on May 28, 2011, 08:33:54 AM

Hi

Any solution on this?
I have the exact same problem :(

regards
i8u

Title: Re: Problem with DCS-2121 after using Reset button
Post by: WyreNut on June 09, 2011, 06:33:40 PM

Jumping in a bit late here, but are you sure you're doing the Factory Reset correctly?  On my Dlink camera (DCS5300G), I have to hold the reset button depressed for two cycles, then release.

Check your user guide.

WyreNut

Title: Re: Problem with DCS-2121 after using Reset button
Post by: davidcam1983 on January 17, 2014, 12:44:07 PM

alguna solucion para esto por favor si pudieran regalar el firware original 1.4 o como instalarlo seria de gran ayufda

Title: Re: Problem with DCS-2121 after using Reset button
Post by: JavaLawyer on January 17, 2014, 12:47:55 PM

You can find the DCS-2121 firmware here: tsd.dlink.com.tw (http://tsd.dlink.com.tw/)