D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-615 => Topic started by: vinod827 on April 18, 2011, 09:27:34 AM

Title: DIR 615 Hardware version C1 frequently restarts...please help ??
Post by: vinod827 on April 18, 2011, 09:27:34 AM

Hi, im using a DLINK DIR 615 N series router.
h/w ver : C1
F/W ver: 3.11NA

It was working fine since few months but recently from past 1 month, my router is keep on getting restarting.
Like, it restarts (red light is on) frequently after every 10 seconds, even i can't get so much of time to reconfigure it.
please provide any solid solutions to it.

thanks alot in advance.

Title: Re: DIR 615 Hardware version C1 frequently restarts...please help ??
Post by: FurryNutz on April 18, 2011, 10:00:55 AM

What ISP do you have DSL or cable?
What ISP Modem do you have? Built in router or stand alone modem?
How are you connecting? Wireless or Wired?
What devices do you have connected? How are they connecting?

Title: Re: DIR 615 Hardware version C1 frequently restarts...please help ??
Post by: vinod827 on April 20, 2011, 08:36:16 AM

Quote from: FurryNutz on April 18, 2011, 10:00:55 AM

What ISP do you have DSL or cable?
What ISP Modem do you have? Built in router or stand alone modem?
How are you connecting? Wireless or Wired?
What devices do you have connected? How are they connecting?

1. BSNL DataOne (India) it is a DSL connection
2. Standalone Modem
3. Trying both wired/wireless but none is working. In both cases getting disconnected
4. Only my laptop. Trying to connect with router through cable so that i can reconfigure my router


Please help.

Title: Re: DIR 615 Hardware version C1 frequently restarts...please help ??
Post by: FurryNutz on April 20, 2011, 08:54:54 AM

Is the router setup for PPPoE?
Turn off ALL devices accept for one PC.
Do a factory reset of the router.
Ensure Primary and 2ndary DNS is being auto filled in under Setup/internet/manual.
Disable Advanced DNS Service.
Enable DNS relay.
Try changing WiFi modes from Mixed to Single mode G to test.

Make sure all cables are in good condition and proper.