D-Link Forums

The Graveyard - Products No Longer Supported => D-Link NetDefend Firewalls => Topic started by: Niko on June 08, 2011, 06:53:57 AM

Title: NAT configuration DFL-210
Post by: Niko on June 08, 2011, 06:53:57 AM

Hello,

Need some help to configure NAT. Need to be able to reach our server externally.
Internally is no problem, but externally I can`t. The server is a monitor server using a software called
N-Able and is installed with the help of Linux. It´s connected directly to the firewall.

How should I configure NAT so I can reach it even if I am outside the network?

Thanks for any help!

BR
Niko

Title: Re: NAT configuration DFL-210
Post by: danilovav on June 11, 2011, 01:20:27 AM

I think, you need SNAT

SAT wan/all-nets core/wan_ip yourservice, SAT: new destination = yourprivatehost
Allow wan/all-nets core/wan_ip yourservice

If public and private ports are different, use public port in service, set private port in SAT tab
If DFL is not default gw for internal server, use NAT instead of Allow in second rule

Title: Re: NAT configuration DFL-210
Post by: scrubsguy on July 21, 2011, 01:07:05 AM

stupid question what service are you using? open vpn, pptp,..etc? do you connect directly via logmein or what?