D-Link Forums
The Graveyard - Products No Longer Supported => D-Link Storage => DNS-320 => Topic started by: jsl262 on June 12, 2011, 10:16:21 PM
-
I just set up dns 320. How do I configure my linksys E2000 to access my hard drive files over the internet. I have set up a dlinkddns account. Any suggestions welcome. How do I activate port 80, as suggested in NAS setup. john
-
Refer to my reply in this thread: http://forums.dlink.com/index.php?topic=38001.0
-
These are the entries in single port forwarding in my linksys e2000 router. I tried a d-link router in an attempt to be compatible on my system, that failed. I returned it.
DNS 320 server
ext port 80 int port 8081 protocol tcp ip: 192.168.1.xxx
I have two d-link cameras they work fine. I am on comcast cable no blocks on their end. Any ideas on how to access my data online.
-
Shouldn't your Ext-port be 8081 and Int-port 80 since NAS web admin listen to port 80 by default?
-
not sure if this helps.. i have a modem and a router both on dhcp.. so i foward 80 from modem to router.. and foward again 80 from router to NAS.. my modem and router both have wan admin turn off..
so when i try to access from the same lan (using public ip / dns).. it will keep going to the modem admin cause althou i disable wan access.. it recognize it as lan.. and i can't get access to the nas.. same with FTP.. it keep trying to connect with the modem ftp..
but when i access using another IP.. from broadband or somewhere outside.. it work just fine.. so maybe you can try access it from elsewhere..
i'm no networking expert but this is hwo i got it work.. trial and error.. hope it help
-
After working with support I am waiting for a senior tech to call. I seem to now see a log in interface. But, i am getting error mssg.
ACCESS ERROR: DATA FOLLOWS
CGI PROCESS FILE DOES NOT EXIST
ANY IDEAS WELCOMED. THANKS