D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DIR-600 => Topic started by: svons7 on July 20, 2011, 10:13:21 AM
-
Hello everyone. I recently hardreset my Dir-600 and now I'm having issues connecting to the firmware.
When i check my default gateway it just gives me a ipv6 address instead of the typical 192.168.0.1 ip.
it seems to assign the ip to my computer properly though.
Also the wifi is broadcasting and I'm able to connect to it since it is unsecured but it still shows that same gateway. does anyone have any experience with this issue and not being able to connect to the firmware? thanks for your help.
-
Try turning off IPv6 services under networking in your windows/pc settings temporarily. What OS are you using?
Also clear your browser cache...Try a different browser too, Opera or FF.
-
ok will do. thanks for the reply. Im currently using xp on one computer and win7 on another. both had the same issue. the win7 was wired the xp wireless.
ill try turning off the ipv6 when i get home.
-
let us know how it goes.
-
just for my knowledge: DIR600 HW B2 FW 2.06 support ipv6?
(in my country area is still ipv4 used, there are some discussions about ipv6...)
thanx!
-
Does the routers web page have IPv6 options under Advanced?
If it does then I would say yes it supports it.
just for my knowledge: DIR600 HW B2 FW 2.06 support ipv6?
(in my country area is still ipv4 used, there are some discussions about ipv6...)
thanx!
-
nope...I already clarified myself, thanx anyway.
-
Hows it going on this?
ok will do. thanks for the reply. Im currently using xp on one computer and win7 on another. both had the same issue. the win7 was wired the xp wireless.
ill try turning off the ipv6 when i get home.