D-Link Forums
D-Link IP Cameras for Home => DCS series Network Cameras => Topic started by: michale32086 on August 16, 2011, 03:49:47 AM
-
I have two DCS 920s that were too close to the edge of the roof. They quit working during a really bad storm that rolled thru..
I did a power reset and then a hard reset..
What happens now is, when I plug in the power, the LED goes red, then green. Then I get 3 flashes of green and then the red comes on and stays on.. It's the same for both of them.
I am assuming that the 3 flashes is some sort of error code.
Anyone have an idea what it means?
Thanx
Michale