D-Link Forums
The Graveyard - Products No Longer Supported => Access Points / Extenders => DAP-1522 => Topic started by: OldTechy on October 22, 2011, 03:16:45 PM
-
the DAP-1522 (Bridge-Mode) is successfully communicating
to a DIR-655 (setup shown below)
The DIR-655 reports 100% signal and 120Mbps.
The DAP-1522 reports solid, 86% signal ...
Since both devices are advertised to be capable of 300Mbps ....
I was hoping to improve on the DAP-1522 throughput rate I am receiving.
Questions ...
1 ) how can DAP-1522 Bridge-Mode Wireless
be configured exactly like DIR-655 wireless?
most of it's Wireless-Bridge settings are
"preset and greyed-out"
2) would the antenna mod kit shown on this link
http://forums.dlink.com/index.php?topic=3740.0 (http://forums.dlink.com/index.php?topic=3740.0)
offer me any improvement in through-put
since I alread have 100% signal ??
thnx for assist
O T
...............................................
DAP-1522 reports
Wireless Mode : Bridge Mode
(FOLLOWING SETTINGS ARE GREYED-OUT & cannot be changed )
Wireless Network Settings
802.11 Band : 2.4GHz/5GHz
802.11 Mode : Mixed 802.11 A B G N
Auto Channel Scan : ENABLED
Wireless Channel : 6
Transmission Rate : Best(automatic)
Channel Width : 20/40 MHz
WPA Mode : WPA Only
Cipher Type : AES
----------- DIR-655 settings -----------
802.11 Mode : Mixed n & G
Auto Channel Scan : DISABLED
Wireless Channel : " 4 "
Transmission Rate : Best (automatic)
Channel Width : Auto 20/40 MHz
WPA Mode : WPA Only
Cipher Type : AES
-
I would change from ALL Mixed mode to Single N mode on both devices if your trying to achieve faster connection speeds. You wont get fast connection speeds at ALL Mixed. Has to be single mode to get 300Mps Connection speeds.