D-Link Forums
The Graveyard - Products No Longer Supported => D-Link Storage => DNS-323 => Topic started by: urnrg on November 25, 2011, 03:13:24 PM
-
Hi. I'm a new DNS-323 owner. This unit was purchased for SOHO.
I want to start a conversation regarding good data management strategy for my situation.
I have a mixed environment: Windows Vista, Windows 7, OS X 10.6 (Snow Leopard).
I purchased this device primarily for backup using RAID 1.
I'm impressed by the mix of features and intend to use most if not all of them.
The strategy I would like to follow is to setup RAID 1 and to have an off-site backup copy.
Two smaller drives have been installed and I want to temporarily use JBOD as a combined volume.
tl;dr
Can I convert the two JBODs into a RAID 1 without losing data?
Is it possible to swap a mirrored drive with an off-site drive on a regular basis?
As my needs grow and larger drives are required, can I expand the RAID capacity by adding new larger drives incrementally?
Thanks.
-
Can I convert the two JBODs into a RAID 1 without losing data?
No
Is it possible to swap a mirrored drive with an off-site drive on a regular basis?
Not recommended - it can be done, but expect to lose data at some point
As my needs grow and larger drives are required, can I expand the RAID capacity by adding new larger drives incrementally?
No
-
Thank you for the quick reply.
Can you comment on the first point of converting JBOD to RAID?
In the user manual it says, "Enables you to change from Non-RAID to RAID 1 configuration without losing data on the hard drives." (PDF, p. 7)
On the third point, I would expect the RAID 1 to increase capacity to the smallest drive capacity.
How then is a RAID 1 capacity increased as required?
-
Thank you for the quick reply.
Can you comment on the first point of converting JBOD to RAID?
In the user manual it says, "Enables you to change from Non-RAID to RAID 1 configuration without losing data on the hard drives." (PDF, p. 7)
The DNS-323 supports converting from Standard Volumes to RAID, but not JBOD to RAID
On the third point, I would expect the RAID 1 to increase capacity to the smallest drive capacity.
How then is a RAID 1 capacity increased as required?
The DNS-323 does not support RAID resizing. The size of a RAID 1 array is determined by the size of the smallest HDD at the time the RAID 1 array is created. Swapping the smallest HDD for a larger HDD at a later time will not re-size the array.
-
Is it possible to swap a mirrored drive with an off-site drive on a regular basis?
I would be wary of routinely swapping drives. Aside from the obvious chance that a RAID array won't be rebuilt properly, you run the risk of damaging the DNS. It isn't designed to have drives swapped in and out on a routine basis.
Regards,
Wiggs
-
Very good, very important information. This modifies the scope of a data management strategy that I was trying to achieve where I could dynamically grow data storage and mitigate against catastrophic loss of data.
I just got my Dec. Entrepreneur issue (p. 46) saying that there is no universal backup solution, to have a good plan in place and that cloud solutions are pricey per buck. This pretty much backs up what my meta senses are saying.
I have a mixed environment where I want to do three things with data which are data storage, data archiving and data backup in co-locations with very reasonable prices. I can't imagine cloud storage prices coming down since they are in tandem with physical drive prices, a la Thailand.
There are a lot of value-added features on the DNS-323 but according to the answers here there is a physical weak point of a statically sized RAID 1 that does not allow for regular hot swapping.
Is this something where a magical firmware update can address some of these issues?
I'll leave it at that for a final word. Now, I'm going to go and formulate a new strategy that doesn't involve throwing a lot of money at it.
-
You may benefit from this sticky post in the ShareCenter FAQ board: Data Backup vs. Redundancy (http://forums.dlink.com/index.php?topic=42033.0)
-
you can get help from here or the answers provided above are also not bad.