D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-601 => Topic started by: airernie on November 30, 2011, 05:25:36 AM

Title: Log flooded with "UDHCPD Received a SIGUSR1" entries
Post by: airernie on November 30, 2011, 05:25:36 AM

I just replaced my older D-Link with a DIR-601.  I decided to try the email feature, so I set the option to "On Log Full".  Within an hour I had 5 emails.  I noticed that they were mostly entries reading "DIR-601 local0.debug udhcpd[18594]: UDHCPD Received a SIGUSR1".   

The "Debug Information" option isn't checked.  Any clue on what is causing these entries?  Especially in this quantity?

Thanks,
Ernie

Title: Re: Log flooded with "UDHCPD Received a SIGUSR1" entries
Post by: FurryNutz on November 30, 2011, 07:43:32 AM

What Hardware version is your router? Look at sticker under router.
What Firmware version is currently loaded? Found on routers web page under status.

What ISP Service do you have? Cable or DSL?
What ISP Modem do you have? Stand Alone or built in router?
What ISP Modem make and model do you have?

Did it only happen after you enabled the email option?