D-Link Forums

The Graveyard - Products No Longer Supported => IP Cameras => DCS-932L => Topic started by: fman3 on December 03, 2011, 06:54:32 AM

Title: DCS-932L will not work after firmware update
Post by: fman3 on December 03, 2011, 06:54:32 AM

Hey guys,
I just received my DCS-932L camera yesterday. I installed it and had it up an running with no problems. While I was checking out the my-dlink web site, it informed me that I needed the newest firmware. I clicked to install the fimeware, and after it installed - my camera led light turned red and hasnt worked since. I have tried reinstalling completly, but I cant even get a green light on my camera using a hard cable connection. I have also tried doing the hard reset. Do you guys have any idea?

thanks

Title: Re: DCS-932L will not work after firmware update
Post by: JavaLawyer on December 03, 2011, 09:11:39 AM

You can try resetting the DCS-932L to the factory default settings and firmware. While the camera is powered up, using a paperclip press and hold the recessed reset button (pinhole on the rear of the camera) for > 8 seconds.

Title: Re: DCS-932L will not work after firmware update
Post by: scottforman on June 30, 2012, 09:18:47 PM

i have exactly the same problem noone knows how to fix it  i new i should have just left it alone it was working fine  thanks for the upgrade dlink nott

Title: Re: DCS-932L will not work after firmware update
Post by: mailming on July 09, 2012, 04:22:14 PM

When updating firmware for any wireless devices, it has to be done via cable Ethernet, if via wireless, most likely it is going to be bricked.

Good luck.

Title: Re: DCS-932L will not work after firmware update
Post by: fromkrypton on July 16, 2012, 08:18:33 AM

Same problem. Red light and can't connect to camera anymore. Is there anything that can be done?