D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-655 => Topic started by: rjb123 on December 15, 2011, 09:43:15 AM

Title: VPN works, Then doesn't then does after restart..
Post by: rjb123 on December 15, 2011, 09:43:15 AM

DIR-655 FW2.0

I have ports open for VPN. It works for 12 hours then the ports appear closed in a port scan. If I uncheck the ports in port forwarding, apply, re-check and apply it works again. If I restart the router it works again.

Thanks!

Title: Re: VPN works, Then doesn't then does after restart..
Post by: FurryNutz on December 15, 2011, 09:50:51 AM

What router options are you using to port forward?

What ISP Service do you have? Cable or DSL?
What ISP Modem do you have? Stand Alone or built in router?
What ISP Modem make and model do you have?
If this modem has a built in router, it's best to bridge the modem. Having 2 routers on the same line can cause connection problems.

Some things to try:
Ensure DNS IP addresses are being filled in under Setup/Internet/Manual? You can find these under Status/Device Info/Wan section.
Turn off ALL QoS (DIR only) GameFuel (DGL only and if ON.) options. Advanced/QoS or Gamefuel.
Turn off Advanced DNS Services if you have this option under Setup/Internet/Manual.
Turn on DNS Relay under Setup/Networking.
Setup DHCP reserved IP addresses for all devices on the router. Setup/Networking
Ensure devices are set to auto obtain an IP address.
Set Firewall settings to Endpoint Independent for TCP and UDP.

Turn off all anti virus and firewall programs on PC while testing. 3rd party firewalls are not generally needed when using routers as they are effective on blocking malicious inbound traffic.
Turn off all devices accept for one wired PC while testing.

Title: Re: VPN works, Then doesn't then does after restart..
Post by: slpip on December 16, 2011, 06:30:52 PM

Try to change the Firewall Setting:
NAT Endpoint Filtering with the Endpoint Independent