D-Link Forums
The Graveyard - Products No Longer Supported => Access Points / Extenders => DAP-1522 => Topic started by: Azaron on January 02, 2012, 05:10:21 AM
-
Hi,
I'm having trouble to get to the configuration page (192.168.0.50) of the DAP-1522. How can I fully reset it? I tried keeping the reset button on the site presses for a while (20secs or so), also with a pin in the reset hole on the back, turning the power off for some time, ...
I just turn the power on, with no network cables plugged in, then connect my laptop to it with a network cable. But i'm never able to get to 192.168.0.50.
When I connect the 1522 with a cable to the rest of my network, I works as a switch without a problem (no wireless though).
When I got the DAP-1522 I thought it had a CD-rom with it, but I don't find that anymore. Is this needed to perform the initial setup of the device? If so, can I download it somewhere? I tried searching for it, but other then firmware updates and pdf's I'm not able to find it.
The device worked fine until I tried resetting it a few days ago. I didn't know the password anymore as I needed to get into the configuration utility.
Many thanks in advance,
Azaron
-
Try using a different browser like Opera or FF.
Ensure that your PC your connecting to set set for a manual static I address, try using 192.168.0.49. Set it back to automatic after your done.
-
Aaah! You made my day. The static IP did it! Before I did do an ipconfig /release and stuff like that, but that didn't do much.
Thanks,
Azaron
-
Enjoy.