D-Link Forums

The Graveyard - Products No Longer Supported => D-Link Storage => DNS-320 => Topic started by: Dalsvzla on February 19, 2012, 08:18:16 PM

Title: Local backup progress indicator
Post by: Dalsvzla on February 19, 2012, 08:18:16 PM

Hi all,


I configured one DNS-320 to make a local backup from other DNS-320 that i have (one backup of the other) but when the process are active the progress indicator (between "save to" and the "status" icon in local backups donest show anything but  a "-" symbol.

Why is this and how can i make to work it?


Regards

Title: Re: Local backup progress indicator
Post by: Dalsvzla on February 21, 2012, 07:29:52 AM

Hi Guys,

Any info about this?


Im seeing that D-link technical support doesnt have and email and i have to call directly by phone.

My English are very bad and i prefer to make this clear by email.

Can you help me with this?

Regards.

Title: Re: Local backup progress indicator
Post by: cable2 on February 22, 2012, 08:18:54 AM

Hi Dalsvzla,
I have a similar backup to yours, which I suspect is rare by the way, and the progress indicator does not appear to work.  This would be a bug of course, but I am afraid it is one of the lowest priority to fix. 
Otherwise, the process does complete and "success" is reported in the 320's web interface and I have verified that the new data is backed up.  I have mine set to do an "incremental" backup, scheduled to run at 2:30 AM, so I am not too concerned about the progress indicator.  Just that the data is backed up.  I doubt that many others have a similar setup so that is why no other responses.  Anyway, I am just glad the backup works.  Good luck and regards

Title: Re: Local backup progress indicator
Post by: ivan on February 22, 2012, 01:56:13 PM

We have the same system here - only our 320 backs up a couple of 323s - but since these backups are scheduled to take place from 3 am there is no one here to see what the progress indicator does, in fact I didn't even know there was supposed to be one.

Title: Re: Local backup progress indicator
Post by: Dalsvzla on February 22, 2012, 05:42:42 PM

Hi Cable2 and Ivan,

Thats right... i have almost the same config starting on 3am with incremental backup and the status always finished as "success", however, im interesting on see the progress a few times...  some of the transfers are very large data.

Well... i hope to see a fix on this soon... its not good when you have a device that must work correctly no matter what a little detail are not working.

Thks guys.