D-Link Forums

The Graveyard - Products No Longer Supported => IP Cameras => DCS-932L => Topic started by: rainersip on March 12, 2012, 12:40:11 AM

Title: 2 DSC-932L, only one can be accessed from WAN
Post by: rainersip on March 12, 2012, 12:40:11 AM

Hi there, I have 2 DSC-932L. I configured them with different port i.e. 19991 and 19992. I'm sure the port forwarding is working cos I can access them on local network. The problem is when I access them through outside internet only one of the cameras is accessible. I checked again with the status of the cameras and found that they have different upnp status:

The working one:
UPnP Port Forwarding   Port already used by gateway

The non working one:
UPnP Port Forwarding   Gateway upnp disable

Can someone please give me a hand? I have enabled upnp and upnp port forwarding in both cameras. Thanks a lot in advance.

Title: Re: 2 DSC-932L, only one can be accessed from WAN
Post by: MMa0blabla on March 15, 2012, 02:31:59 AM

Hi,
upnp is buggy ont this camera's latest firmware, disabling it on the camera's control panel does not work.
The only solution is to disable upnpn on your router (if you can) then configure port forwarding by hand on it.
Hope this will help...

Title: Re: 2 DSC-932L, only one can be accessed from WAN
Post by: rainersip on March 16, 2012, 07:53:01 AM

It seemed working. You are a lifesaver  ;D