D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DIR-655 => Topic started by: Jerry859 on April 04, 2012, 09:57:56 PM
-
I have an HP OfficeJet J4500 that works fine with shareport on my Win7 x64 computer. the XP and Win2000 ones both have the same "partial page then lockup" problem. when this happens, the only way to disconnect shareport is to reboot the router. It shows connected to the same computer even if I reboot that computer. I started with V1?? from the install disk then tried 3 and finally 4 with no improvement. I have read several posts about this or similar problems. Can't someone fix this please. This is the primary reason I switched routers and bought the D-Link DIR-655, for the print server feature...
-
Hi,
I am surprised your shareport is working with the x64 system...usually, those are the ones that seem to conflict with shareport the most....
Not meaning to be a mojo-killer, but I would suggest you have a "Plan B" ready to go.... Printing on a network with a non-network printer is a hack to start with....and sadly it seems to go down from there....
Unless you don't mind sharing a printer from a pc and leaving that pc on all the time in case you might need to print....
SD1
-
I use v4 with my 7x64 and it works with my HP Laserjet. My router is Rev B1 FWv2.03.
Any 3rd party security SW running while testing? Might turn this off temporarily to test.
What Hardware version is your router? Look at sticker under router.
What Firmware (http://forums.dlink.com/index.php?topic=42458.0) version is currently loaded? Found on routers web page under status.
-
Silex support said they can't help me cause they don't support DLink routers.... wah