D-Link Forums
The Graveyard - Products No Longer Supported => D-Link Storage => DNS-321 => Topic started by: demosdoulou on March 20, 2009, 03:35:24 PM
-
How do you set the daylight savings time? I have FW 1.01 but I cannot find a check box for daylight savings.
thanks
-
Apparently the only explanation is, it has been left out!!
-
There was a thread on the 323 forum about this. D-Link said that they would address this, and for now the workaround was to set the unit to a different time zone.
-
There was a thread on the 323 forum about this. D-Link said that they would address this, and for now the workaround was to set the unit to a different time zone.
Can you link to that thread? I have a suspicion you're confusing two different issues - the DNS-323 has (in fw 1.06), and as far as I can recall, has always had a checkbox to enable/disable daylight saving time - I believe the thread you're thinking of may have referred to an issue relating to the "new" daylight saving time "change dates", causing the time to be incorrect.
Where I am, DST is not used, so I invariably have to find that check box and disable it.
-
Where I am, DST is not used, so I invariably have to find that check box and disable it.
My kin on my fathers side come from Indiana (until 2006 no DST), they have all moved to Arizona (no DST), some part of me thinks that they were just moving on a pretence to not have to change the clocks twice a year. Some part of me wonders if they aren't wiser for it, then I remember that Arizona is only a full 18" from hell itself in most places.
Do they sell air conditioned bubbles yet?
-
Okay, so the fix for no DST selection on the box is to move to AZ! You heard it here folks! ;D
-
Okay, so the fix for no DST selection on the box is to move to AZ! You heard it here folks! ;D
What a price to pay though. It is bad enough visiting AZ for holidays.
-
This will be resolved in future firmware however I do not have a release date at this time.