D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DIR-655 => Topic started by: Happy2cu on April 12, 2012, 10:03:05 AM
-
All the light on the router blink on and off. Then the router resets and loops all over again?
-
Do a factory reset of the router.
Swap out the LAN cable between router and PC. Cat6 is recommended. (http://www.networkcablingdirectory.com/articles/structured-network-cabling-id_1151.htm)
-
Yes did that ??? cant seem to figure out the issue? is there a way to do a hard reset?
-
Might try the FW update sticky at the top of the forum and see if you can get into recovery mode.
Is this a new router or old one?
How long have you had the router?
-
Old router, firm 1.21.
-
You had v1.21 on it and then upgraded to 2.00?
or is this a different router your talking about. I see you posted a Rev B 2.00 router in your other post.
You can't using any v1.x versions on Rev B routers and vs you can put v2.x versions on Rev A routers.
-
H/W VER:B1 F/W VER.2.00NA
-
What does Old router, v1.21 that you mentioned have to deal with? This is getting confusing.
-
Sorry, I have 3 routers:
1 Blinking All Lights: B1 fw 2.00na
2light on but no connection A2 fw 1.11
3light on but no connection A4 fw 1.21
-
1 Blinking All Lights: B1 fw 2.00na >Link: RMA Creation (http://rma.dlink.com/)
RMA Support FAQ (http://www.dlink.com/support/faq/?question=general-rma&page=1/)
2light on but no connection A2 fw 1.11 >Factory reset or get to Recovery mode?
3light on but no connection A4 fw 1.21 >Factory reset or get to Recovery mode?