D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DIR-615 => Topic started by: sharkrc on April 16, 2012, 12:52:07 PM
-
I have a couple ip cameras that need like 2 ports each and 1 app that needs 1 port forwarded. If I put the IP in the DMZ it works fine, I have tried pfconf and also simple port forwarding tools but neither work. They add the info in, but the port is still closed,I have a cable modem,and everything works fine if the ip is listed in the DMZ.Is there any way to list 3 of them in there. I have firmware 2.25 I see there is a newer firmware out there should I upgrade..??
Thanks for any help
-
Welcome! (http://forums.dlink.com/index.php?topic=42487.0)
What Hardware version is your router? Look at sticker under router.
What Firmware (http://forums.dlink.com/index.php?topic=42458.0) version is currently loaded? Found on routers web page under status.
What region are you located?
DMZ only allows for one device IP address to be used.
I belive you have the latest version if you have a Rev B router.
Does your router settings have a QoS option under Advanced with some rule entries listed? Or just QoS enable or disable?
What ISP Modem make and model do you have?
Some things to try:
Turn off ALL QoS or Disable Traffic Shaping (DIR only) GameFuel (DGL only and if ON.) options. Advanced/QoS or Gamefuel.
Turn off Advanced DNS Services if you have this option under Setup/Internet/Manual.
Turn on DNS Relay under Setup/Networking.
Setup DHCP reserved IP addresses for all devices ON the router. Setup/Networking
Ensure devices are set to auto obtain an IP address.
Set Firewall settings to Endpoint Independent for TCP and UDP under Advanced/Firewall.
Enable uPnP and Multi-cast Streaming under Advanced/Networking.
-
router version is v2.25
Turn off ALL QoS or Disable ----I disabled this
Turn off Advanced DNS ----looking for this
Turn on DNS Relay-------- this is on
Setup DHCP reserved IP addresses for all devices ON the router. Setup/Networking --- will check
Ensure devices are set to auto obtain an IP address. my camera's have a static IP
Set Firewall settings to Endpoint Independent for TCP and UDP ---- they were'nt but are now
Enable uPnP and Multi-cast Streaming under Advanced/Networking. ---these are on.
Will try some more tommorrow,thanks for the help