D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DGL-4500 => Topic started by: nightwingfx on April 06, 2009, 09:02:16 AM
-
Greetings everyone,
I have been a frequent visitor of this forum and finally registered!. I have a question about the settings in the NAT ENDPOINT FILTERING section.
From browsing through this forum I noticed that some suggested to set both UDP/TCP Endpoint filtering to ENDPOINT INDEPENDENT. Are these settings optimal and secure at all? Not sure if it's related but do I need to forward ports at all if I used these settings?
Am I better off staying with the default setting such as:
UDP ENDPOINT Filtering - Address Restricted
TCP ENDPOINT Filtering - Port and Address Restricted
Thanks for the help. I have no clue when it comes to networking ;D