D-Link Forums

The Graveyard - Products No Longer Supported => IP Cameras => DCS-932L => Topic started by: scottforman on June 30, 2012, 03:14:54 PM

Title: dcs932l cant reset or anything after firmware dload helpp
Post by: scottforman on June 30, 2012, 03:14:54 PM

i downloaded the new firmware now i cant  reset or do anything with my 932l the light stays red  it worked perfect before  ive tried everything  can anyone help or will dlink send a new one

Title: Re: dcs932l cant reset or anything after firmware dload helpp
Post by: JavaLawyer on July 01, 2012, 10:08:34 AM

Two things to try: While the DCS-932L is powered-up, press and hold the recessed reset button on the rear of the camera with a paperclip for >6 seconds. This procedure should reset the camera to the factory defaults. Alternatively, if you have access to the DCS-932L administrative web interface (via a browser), you can upload an older version of the firmware.

Title: Re: dcs932l cant reset or anything after firmware dload helpp
Post by: photogopher on January 21, 2015, 03:15:09 PM

I too like most on this subject have made the mistake in clicking on the update button when signing in to my camera via my smart phone Android app.  Nothing I do according to the afore mentioned instructions will bring the camera back to a factory state.  While this camera was fairly inexpensive, it worked well and met my needs.  Now, it's just a paperweight.
I don't see any concerned reply from D-Link regarding this problem.  I'll start it in a new topic just the same.