D-Link Forums
The Graveyard - Products No Longer Supported => Routers / COVR => DIR-655 => Topic started by: Backdoctor52 on November 24, 2012, 07:04:42 AM
-
:'(
I have had a DIR-655 router for a few years now, but slowly over time the wireless output has gone down. I have tried changing parameters to only-g or only-n, rebooted, changed other parameters based on what I have read in some of the forums, but have not been able to restore the power. It has an ANT24-230 antenna, and the latest firmware update 1.35NA. Different devices all show the same thing, that even next to the antenna the strength is only 80% in spite of the fact that the wireless output is set to max.
Any comments would be appreciated, even though I have been working on this for a couple of months now, and am considering buying a new 11AC or 900N router if this is not fixable.
-
Link>Wireless Installation Considerations (http://forums.dlink.com/index.php?topic=48327.0)
Try single mode G or N or mixed G and N?
Channel Width set for Auto 20/40Mhz or try 20Mhz only.
Try setting a manual channel to a open or unused channel. 1, 6 or 11. 11 for single mode N if the channel is clear.
What security mode are you using? Preferred security is WPA-Personal. WPA2/AES Only. Some WiFi adapters don't support AES, so you might want to try TPIK only or Auto.
What wireless devices do you have connected?
Any cordless house phones?
Any other WiFi routers in the area? Link> Use InSSIDer (http://www.metageek.net/) to find out. How many?
Turn off WISH, and WPS under Advanced.
Try turning off Short GI, WLAN Partition,and Extra Wireless Protection if you have it. Under Advanced/Advanced Wireless.
Enable WMM Enable (http://forums.dlink.com/index.php?topic=50738.0) Under Advanced/Advanced Wireless.
-
Any status on this? ???