D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-930L => Topic started by: RoarinRow on March 04, 2013, 01:46:19 PM
-
I have two cameras I was fiddling with. Before one of them got messed up I was trying to make them available from outside my network. While I was messing with the settings the cameras froze and I had to restore them back to factory settings and go through the wizard again.
One camera came up fine, even though I was getting an error message during the wizard install that it was having problems with the password and click next to continue to retry. I tried everything until I finally rolled back the firmware from 1.08 to 1.05.
After rolling back to 1.05 I was able to add my first camera and the quality was as it was from the first install a couple of days ago.
My second camera, however, did not have such luck. I was able to add it, but the quality got really bad, almost cloudy looking. I tried to change the resolution to the highest setting with the highest quality, but that didn't work.
I tried to upgrade several times from firmware 1.05 all the way back to 1.08, no luck. Picture is still fuzzy/cloudy. For now both cameras are on version 1.07.
I installed the new wizard version that didn't help. I tried to change wireless changes, but that didn't work. I tried to unplug the first camera so the second was the only camera on the network, thinking it was a bandwidth issue. That didn't work.
Any suggestions? Please.