D-Link Forums
The Graveyard - Products No Longer Supported => IP Cameras => DCS-930L => Topic started by: Notworried on April 18, 2013, 09:05:37 AM
-
The upgrade(which I was doing over the internet and had worked before) never finished and when I exited installation the camera cannot be reached. What is the solution?
-
Assuming you have local access to the camera, you can perform a factory reset, hardwire the camera, and reattempt the installation.
-
Thanks. What I learned was that I did not have to plug the camera to the router and use D-Link's wizard. I just direct connected it to the Ethernet port. Oh, I skipped firmware upgrade. 1.00 is just fine!
-
The upgrade(which I was doing over the internet and had worked before) never finished and when I exited installation the camera cannot be reached. What is the solution?
??? How in the world do you do it that way? ???
-
Thanks. What I learned was that I did not have to plug the camera to the router and use D-Link's wizard. I just direct connected it to the Ethernet port. Oh, I skipped firmware upgrade. 1.00 is just fine!
Was the file zipped up? Did you unzip it? Probably not. Nice move.
-
Umm, yeah, I usually unzip files before using them. I think I learned that in 1984.
-
Umm, yeah, I usually unzip files before using them. I think I learned that in 1984.
So did u figure it out?
-
Guys, if you are curious what happened, I answered it on April 18 in my second post! And no, I did not have to buy another camera. The old firmware is working fine.