D-Link Forums

The Graveyard - Products No Longer Supported => Access Points / Extenders => DAP-1360 => Topic started by: m.abdelbaqy on April 28, 2013, 03:49:23 PM

Title: DAP-1360 - Bridge
Post by: m.abdelbaqy on April 28, 2013, 03:49:23 PM

Kindly assist me to configure two DAP-1360 as Bridge Mode and Bridge mode AP. kindly help me.

Title: Re: DAP-1360 - Bridge
Post by: FurryNutz on April 28, 2013, 03:56:15 PM

Should be able to run thru the on board wizard to set up the 1360 seen here:
http://www.support.dlink.com/emulators/dap1360/101/index.htm (http://www.support.dlink.com/emulators/dap1360/101/index.htm)

Just having it connect to the main host routers wifi SSID signal.

Title: Re: DAP-1360 - Bridge
Post by: m.abdelbaqy on April 28, 2013, 04:06:36 PM

Thank you for your reply, FurryNutz.
I made it as a Bridge. I got a fix Wireless network SSID "Dlink", added the mac address for the another one,made a WEP security, and typed 10 numbers for password. I did these steps for both of them, but they didnt connect.
I think it is supposed that the site survey shouldnt be highlighted, I should search for the wireless using the second one.
kindly assist me.

Title: Re: DAP-1360 - Bridge
Post by: m.abdelbaqy on April 28, 2013, 04:08:58 PM

one of them is connected from a router, and the other one is connected to a switch via cables

Title: Re: DAP-1360 - Bridge
Post by: FurryNutz on April 30, 2013, 07:22:37 AM

If both are wired connected the use then in AP mode. They can use the same SSID and pw for the WiFi access however just make sure they are using different channels. Set one of them to 1 or 6 and the other to 11. Make sure the main host router is using a different channel as well if it's broadcasting Wifi radio.