D-Link Forums

The Graveyard - Products No Longer Supported => IP Cameras => DCS-2132L => Topic started by: gtomig on April 30, 2013, 04:15:48 PM

Title: Total Cycling Recording Size - Loop recording
Post by: gtomig on April 30, 2013, 04:15:48 PM

OK
I have Total Cycling Recording Size set to 1000 Mb.
Camera already uploaded to my NAS server 27000Mb of data.
What is wrong???

I need loop recording not record-until-disk-full recording.

Title: Re: Total Cycling Recording Size - Loop recording
Post by: RYAT3 on April 30, 2013, 05:02:05 PM

Quote from: gtomig on April 30, 2013, 04:15:48 PM

OK
I have Total Cycling Recording Size set to 1000 Mb.
Camera already uploaded to my NAS server 27000Mb of data.
What is wrong???

I need loop recording not record-until-disk-full recording.

If you are using NAS, the instructions say this, it says nothing about filling it in with a value:

Total cycling recording size: Please input the network path of your network storage, it will like "\\DNS\IPCamRecord\". If the network storage need authentication, please enter your user name and password here.

My DCS 2230 says the same thing.

Title: Re: Total Cycling Recording Size - Loop recording
Post by: gtomig on May 02, 2013, 10:37:00 AM

In other words cycling is not possible and I am to delete older recordings manually....? Ok

Title: Re: Total Cycling Recording Size - Loop recording
Post by: RYAT3 on May 03, 2013, 08:53:18 PM

Quote from: gtomig on May 02, 2013, 10:37:00 AM

In other words cycling is not possible and I am to delete older recordings manually....? Ok

honestly - I have no clue.  I was just trying to point out total clown instructions in the firmware stuff.