D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-615 => Topic started by: illuminated on May 10, 2013, 05:41:31 PM

Title: Worked at first, then disconnected, then I flashed to dd wrt, now it doesnt work
Post by: illuminated on May 10, 2013, 05:41:31 PM

hello!

i recently bought my dir-615 to hook up with my tp- td 8816 modem. After setting it up and successfully working one day, the router randomly stopped sending a wifi signal. I restarted it twice and it began to work once more. I decided to install dd wrt build 21061 for my E3 dir -615 router. Unfortunately, i could not get it to work. I have dsl internet and my isp uses PPPoE. I used the option for the set up and filled out the appropriate information, but it would not work and the internet light on the router would turn orange.

Unfortunately i decided to play around with this router at the wrong time and the people in my house needed it. I decided to quickly reflash it by going into the emergency room(holding reset button during router reset until orange button starts blinking). However when i select the official d link firmware, it simply will not change. The page is stuck loading on the d-link emergency room page with no progression whatsoever. I tried the process 3 times already.

For some reason, i can connect to the router through wifi but not through cable. When i connect through wifi i am on the dd wrt firmware. I dont think i can return the modem to the store since it is clearly on DD WRT firmware.

Can anyone please help? I'm either looking for a solution to reflashing back to stock firmware, or making the internet work on the dd wrt firmware. The internet light turns orange when i select PPPoE on the set up...

my set up on dd wrt:

(http://i.imgur.com/8rFgEyA.jpg)

Title: Re: Worked at first, then disconnected, then I flashed to dd wrt, now it doesnt work
Post by: FurryNutz on May 10, 2013, 06:01:14 PM

Try this to get it back to OEM FW.
url=http://forums.dlink.com/index.php?topic=44909.0]

You'll need to refer to WRT support sites for help on configuring WRT FW.

Good Luck.

Title: Re: Worked at first, then disconnected, then I flashed to dd wrt, now it doesnt work
Post by: illuminated on May 10, 2013, 06:16:44 PM

Quote from: FurryNutz on May 10, 2013, 06:01:14 PM

Try this to get it back to OEM FW.
url=http://forums.dlink.com/index.php?topic=44909.0]

You'll need to refer to WRT support sites for help on configuring WRT FW.

Good Luck.

Thanks, but when i try the emergency room, it either won't load "192.168.0.1" or it will but when i click send/upload the page stays the same. It's like the page is loading forever...

Do you think it is bricked?

Title: Re: Worked at first, then disconnected, then I flashed to dd wrt, now it doesnt work
Post by: FurryNutz on May 11, 2013, 09:55:57 AM

Check the WRT site for information on reverting back to stock FW.
If that doesn't work then you'll need to RMA the 615 back to D-Link.

Good Luck.