D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DGL-4500 => Topic started by: cevan on May 11, 2009, 05:30:14 PM

Title: Remote Admin Help
Post by: cevan on May 11, 2009, 05:30:14 PM

Hi All,

I'm trying to enable Remote Administration on my DGL-4500 FW - 1.20NA ... I enabled Remote Management set the port but the Admin page never comes up. I have tried different ports and Https but nothing. FTP and RDC all works fine.  Any ideas ?? Same Problem ???

Thanks ...

Title: Re: Remote Admin Help
Post by: arod on May 11, 2009, 05:57:26 PM

What port did you try? Where are you trying to access router from? (the WAN side or the LAN side)
Did you configure your router from scratch or did you load a config from older firmware? Please give us more detail.

Title: Re: Remote Admin Help
Post by: cevan on May 12, 2009, 06:00:35 AM

I tried port 8080, Https 8181, 1234 ... I was trying to connect WAN side. I upgraded to new firmware, reset fac defaults and loaded configs from just before the update.

Title: Re: Remote Admin Help
Post by: Lycan on May 12, 2009, 08:19:48 AM

So you're trying to access the REMOTE ADMIN from the Lan? Thats looping back, you can't do that with SPI on.