D-Link Forums

The Graveyard - Products No Longer Supported => D-Link NetDefend Firewalls => Topic started by: lezde716 on May 27, 2013, 12:30:39 AM

Title: traffic shape on dual wan failover
Post by: lezde716 on May 27, 2013, 12:30:39 AM

in the guide provided by d-link the traffic shaping is only set to only one interface "wan1". So what about if I set my dfl-800 to dual wan failover and both wan has a different bandwidth. wan1 has 6mb and wan2 has upto 5mb. how can i set my traffic shaping?

Title: Re: traffic shape on dual wan failover
Post by: chechito on June 05, 2013, 02:25:59 PM

you must create independent pipes and pipe rules to traffic on each interface.

Title: Re: traffic shape on dual wan failover
Post by: sergiomnt on September 06, 2013, 11:48:50 AM

Hello,

You can do this by Rule of Traffic Shaping, but for this to work your Failover must be ok.

Thank you.
Sérgio de Souza
sergio@masternet.com.br

Title: Re: traffic shape on dual wan failover
Post by: lezde716 on November 21, 2013, 07:37:32 PM

The following are example of my rules:
 
1    drop_smb-all    Drop    lan    lannet    wans     all-nets    smb-all
2    allow_http            NAT    lan    lannet    wans     all-nets    http-all
3    allow_dns            NAT    lan    lannet    wans     all-nets    dns-all
4    allow_ntp            NAT    lan    lannet    wans     all-nets    ntp

In the Interface Group under Interfaces I made a group called wans which is compose of wan1 and wan2.
With this configuration the traffic transfer automatically from the wan2, but as I said you have to manually remove the cable from wan1 port to be able to detour the traffic.

may you have some ideas or suggestion regarding my problem.