D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-615 => Topic started by: regazzo on June 14, 2013, 06:12:29 AM

Title: Desabilitar NAT D-Link DIR-615
Post by: regazzo on June 14, 2013, 06:12:29 AM
Good morning everyone,

I have a DIR-615, and I need to make a configuration for a specific application.

Network connected two cables on my router, the WAN port, and one LAN port.

In WAN settings, put the IP: 192.168.250.18 - Subnet: 255.255.255.0 - Gateway / DNS: 192.168.250.17

In the LAN settings, put the following IP: 10.0.0.2 - Subnet: 255.0.0.0 - Gateway / DNS: 10.0.0.1

I enabled DHCP: 10.0.0.100 - 10.0.0.200

Today the D-link is returning to the network WAN IP: 192.168.250.18, but I need it to return to the IP network generated by DHCP which was attributed to clinente, for example 10.0.0.100.

Its output disable this NAT?

Thank you.

Cristian Regazzo
Title: Re: Desabilitar NAT D-Link DIR-615
Post by: FurryNutz on June 14, 2013, 07:38:10 AM
 Turning a router into an AP. (http://forums.dlink.com/index.php?topic=40856.0)
Title: Re: Desabilitar NAT D-Link DIR-615
Post by: regazzo on June 15, 2013, 04:10:51 AM
FurryNutz Morning, how are you?

Thank you for the prompt help.

Did the configuration as the post, but the computers that connect to D-Link, with the station being in the range 192.168.250.x IP, which is generated by DHCP from my Windows 2008 Server, but I need that IPs assigned these computers connected to the D-link, be in the range of IP 10.0.0.x.

Is setting this up on DIR-615?

Thank you.

Cristian Regazzo
Title: Re: Desabilitar NAT D-Link DIR-615
Post by: FurryNutz on June 15, 2013, 11:03:42 AM
Try this with the 615:
 How to extend network without AP Mode using a Router (http://forums.dlink.com/index.php?topic=53250.msg202549#msg202549)

You'll need to set the 615 IP address pool and router IP address to the 10.0.0.x range.
Title: Re: Desabilitar NAT D-Link DIR-615
Post by: regazzo on June 16, 2013, 08:03:01 AM
Morning FurryNutz once again for your help.

It was precisely this configuration mentioned in the post you refer to, I did the first time.

The Cablo my LAN (192.168.250.18) called the WAN from my DIR-615.

Cofigurei IP 10.0.0.2 on the LAN and I enabled DHCP in the following Range: 10.0.0.10 - 10.0.0.30

However the IP that is returned to my network is the WAN IP: 192.168.250.18, but the application I'm using the DIR-615, I need it to return the generated IP by DHCP, if any between IP 10.0.0.10 and 10.0.0.30.

It is precisely this that NAT disable'm not getting the DIR-615.

I need him Devola the DHCP IP and not the IP WAN.

Is to make such a setting?

Thank you and sorry for so many questions, I'm trying to set this up two weeks without success.

Thanks again,

Cristian Regazzo