D-Link Forums

The Graveyard - Products No Longer Supported => Routers / COVR => DIR-505 => Topic started by: danymora131 on August 05, 2013, 06:18:55 PM

Title: Red Light
Post by: danymora131 on August 05, 2013, 06:18:55 PM

I put my DIR-505 on hotspot mode and I accidentally disconnected it. Now I only get a red light and can't reset or do anything with it. I left it connected over night but I still get the red light. After updating the firmware to the latest it ran smoothly but now it will not work. I can't connect to it even with ethernet.

Title: Re: Red Light
Post by: holmes4 on August 08, 2013, 07:54:58 AM

Did you do the reset by pushing a paperclip into the hole between the two jacks - hold it in until the LED flashes.

Title: Re: Red Light
Post by: danymora131 on August 08, 2013, 05:47:06 PM

I held it for over a minute and it still didn't flash. I disconnected and reconnected it to the power and tried again and it didn't do anything

Title: Re: Red Light
Post by: FurryNutz on August 08, 2013, 06:19:38 PM

You may need to phone contact your regional D-Link support office and get some additional help..Even RMA.