D-Link Forums

The Graveyard - Products No Longer Supported => IP Cameras => DCS-2132L => Topic started by: fliebe on August 19, 2013, 12:01:50 PM

Title: Infrared light flashes every 2 sec
Post by: fliebe on August 19, 2013, 12:01:50 PM

When activate the IR light "IR Light Control" is On or Sync or Schedule. Its become red only for 30 sec. after that, become off and on every 2 seconds and the image changes from dark to bright.

I use FW DCS-2132L_A1_FW_V1.01.10 and then try the 08 version , but are the same

I setup 3 cameras and only one do this ....

Some ideas?

Best regards
Fernando

Title: Re: Infrared light flashes every 2 sec
Post by: oranges on August 19, 2013, 12:22:14 PM

Have you tried Firmware: 1.01.06? Just curious cause i seemed to have some issues with infrared after i upgraded to DCS-2132L_A1_FW_V1.01.10. I downgraded to .06 and my issue seems to be resolved.

Title: Re: Infrared light flashes every 2 sec
Post by: fliebe on August 19, 2013, 01:45:11 PM

I only find

FW v 1.00_06
FW v 1.01.08 
FW v 1.01.10 

Are you sure about 1.01.06

I try 1.00_06 and is the same , IR still flashing  :(

Fernando

Title: Re: Infrared light flashes every 2 sec
Post by: oranges on August 20, 2013, 07:38:24 AM

My bad, it was 1.00_06.

Title: Re: Infrared light flashes every 2 sec
Post by: fliebe on August 23, 2013, 11:35:07 AM

I think is hardware failure , a try reset , all FW an nothing

I bought 3 units and only one has this behavior

Bad luck

Fernando