D-Link Forums

The Graveyard - Products No Longer Supported => Other D-Link Products => Topic started by: motevallizadeh on August 30, 2013, 12:07:51 PM

Title: GSM Modem D-LINK DWM-156 In USSD Commands
Post by: motevallizadeh on August 30, 2013, 12:07:51 PM

i used windows hypertrminal to send USSD commands by my New  GSM Modem:
D-LINK DWM-156 HW ver:A7 and F/W ver:7.0.1.ME.

i send AT and retrive OK

Send: AT+CUSD=1,"*100#",15

i just receive "AT+CUSD=1,\"*100*1#\"\r\n\OK\r\n" and not another message in hyper terminal windows.

i go to check these commands with another modem and my phone and they returned operator message but i can not retrieve operator message on this model of modem what is wrong with me?
please guide me

i send these command with modems own windows application and it works fine and i found that this model of modem may be have special command before or after sending USSD commands

I'm confuse because this is the simple command and it should works.

Title: Re: GSM Modem D-LINK DWM-156 In USSD Commands
Post by: FurryNutz on August 30, 2013, 12:34:05 PM

You'll need to phone contact your regional D-Link support office and ask about this.