D-Link Forums

The Graveyard - Products No Longer Supported => Access Points / Extenders => DAP-1522 => Topic started by: Silverking on September 21, 2013, 06:30:33 PM

Title: Possible failed fw update
Post by: Silverking on September 21, 2013, 06:30:33 PM

Ok, so I have recently purchased a new Dlink DAP-1522 rev. B1 and was setting it up. After playing around with it for a while to get a hang of the features I reset to factory defaults. After this I set an admin password and then did the fw update from 2.02 to 2.04. After the reset I can get to the admin page but it tells me incorrect password or user name. I have tried both the blank default and also the password that I used prior to the update. Also now when doing the hard reset I am getting no change to the 'incorrect password'. Is there a way to do a fw update outside of the admin page or another way to reset to factory defaults? Thank you for your help

Title: Re: Possible failed fw update
Post by: motherfo on September 21, 2013, 06:40:45 PM

Try these emergency flash instructions.  Your ip will most likely be different and the default. 192.168.0.50

http://forums.dlink.com/index.php?topic=44909.0

Title: Re: Possible failed fw update
Post by: FurryNutz on October 08, 2013, 07:05:23 AM

Any status on this?